The following chart gives comprehensive information on
what each book contains
along with number of pages, dimensions, and author info and chapter contents.
|
Book Part Number: |
B-145 |
Title: |
How to Build & Power Tune Weber & Dellorto Carbs | ||||
| Secondary Title: | DCOE & DHLA Carburetors | ||||||
|
Author: |
Des Hammill | ||||||
|
Book Dimensions: |
8 x 10 |
# Pages: |
111 |
Cover: |
Soft |
Text/Pictures: |
B&W |
| Preview front and back cover : | |||||||
|
Introduction |
Weber DCOE vs Dellorto DHLA | ||||||
|
Information |
Using this book | ||||||
|
Chapter 1: |
Strip down & Inspection. Major Compopnents, general advice, inspecting for wear, difficult procedures | ||||||
|
Chapter 2: |
Rebuilding. Floats & float levels, needle valve & seat, top covers, body components | ||||||
| Chapter 3: | Fuel Management. Air filters & ram tubes, fuel lines, fuel pressure, fuel filters. | ||||||
| Chapter 4: | Choosing the components for your carbs, choke size - selecting, Idle jets, Idle jet codes, idle screw adjustment procedure, main jet selection, emulsion tube selection, air corrector selection, aux venturi selection, accel pump selection, needle valve selection. | ||||||
| Chapter 5: | Manifold prep and carburetor fitting, importance of stud alignment, checking fit, anti-vibration mountings. | ||||||
| Chapter 6: | Testing & setup. Idle speed, fuel level & needle valve, throttle - initial adjustment, full throttle check, ignition timing-general, idle jets & air bleeds - final selection. | ||||||
| Chapter 7: | Testing & problem solving. Chassis dyno testing, track testing, solving problems - low to mid range, solving problems - high rpm, tuning by exhaust gas co%, maintenance. | ||||||
| Chapter 8: | Jetting sizing examples: 1275 A-Series - Dellorto & Weber, Pinto 2000cc SOHC, Vauxhaull 2000cc 16v, Sierra Cosworth 2000cc, 1900cc MGB, MGB 1940cc alloy 8-port head, Ford 1600 x-flow, ford 1628 x-flow, | ||||||
| Glossary | |||||||
| Publisher details: | SpeedPro Series UK 1996 | ||||||